Posts made by Rick Kruger

• setting any taper

  There is a setting in the Config space for setting the option to create MHM reports with outputs.  Also, the place for generating reports is on the last tab of the Taper Translation module.&nb...

  posted in General Bamboo Rod Building

  RK

  Rick Kruger
  4/20/23, 9:44 PM
• Gaposis, Gaposis, Gaposis

  I posted this to the Rodmakers list, but want to ask it here also in case there are MHM users that are not on that list: I am dismayed, disillusioned, distressed, disappointed, disgusted, disheart...

  posted in Morgan Hand Mill

  RK

  Rick Kruger
  8/10/22, 2:26 PM
• Great News, New MHM Forum

  That is very curious.  I've only accessed the forum on a non-Apple deviceI, so no clue on if it is an Apple related quirk.  I think its an issue for the forum moderator/administrator.&nbs...

  posted in Morgan Hand Mill

  RK

  Rick Kruger
  4/9/22, 11:20 PM
• Great News, New MHM Forum

  @Mike Falduto  At the main forum page, there does not seem to be a way to create a topic.  It appears one must be in a topic subforum in order to start a new topic. 

  posted in Morgan Hand Mill

  RK

  Rick Kruger
  4/8/22, 7:28 AM
• Staggering, Section Lengths and Extra End Length for Planing and Cutoffs

  Text of my full message to Rodmakers is below.  In regard to extra length on each end, what are you all using?  Tom's manual says 3" one each end and 2" more on the butt section for the h...

  posted in Morgan Hand Mill

  RK

  Rick Kruger
  3/13/22, 7:15 PM
• Soaking and Taper Planing

  I've just completed prepping a bunch of strips and am ready to start planing tapers.  I have yet to do all the staggering and grouping for rod sections but will do that in the next couple days...

  posted in Morgan Hand Mill

  RK

  Rick Kruger
  3/11/22, 9:45 AM
• setting any taper

  RodLab exports MHM settings (does the conversion) as well as doing dynamic conversion of geometries.  I used it to convert a Leonard 38 ACM (1960) 7ft 4wt to a 6ft 2wt which I am currently wor...

  posted in General Bamboo Rod Building

  RK

  Rick Kruger
  2/23/22, 7:53 AM
• Great News, New MHM Forum

  So glad to see this.  We've been waiting quite a while.  Looks great so far.  Nice that there are some subforums.  Looking forward to getting started seriously with making rods ...

  posted in Morgan Hand Mill

  RK

  Rick Kruger
  2/10/22, 4:50 PM